Weiconlock AN 305-74 Flange Sealing Adhesive is a high strength, high viscosity grade of liquid gasket adhesive. This grade is perfect for creating quick and easy yet permanent seals when you don’t have time to cut or wait for a paper, fibre or cork gasket. When used to seal low pressures, Weiconlock AN 305-74 Flange Sealing Adhesive will offer an immediate sealing effect and will be fully cured in about 12 hours. Because its an anaerobic adhesive that must be in contact with metal and deprived of air to cure, it offers almost unlimited working time so you can ensure that even the most complex of flange facings is properly coated before mating. Weiconlock AN 305-74 Flange Sealing Adhesive is typically used to create gaskets for flanges, gearboxes and other motor housings and will cover gaps up to 0.5mm. Technical Details Colour Orange For Threaded Joints Up To — Viscosity at 25ºC Brookfield 30,000 – 100,000 mPa Gap filling capacity (max.) 0.5mm Breakaway Strength (Thread) 16 – 24 Nm Prevailing Strength (Thread) 5 – 10 Nm Shear Strength (DIN 54452) 5 – 10 N/mm² Handling Strength at Room Temp. 15-30 min. (approx.) Final Strength at Room Temp. 12 Hours (approx.) Temperature Resistance -60ºC to 180ºC  Available Sizes Weiconlock AN 305-74 Flange Sealing Adhesive is available from your local Associated Gaskets branch in 50ml or 200ml bottles. These special pen shaped bottle allow for easy, accurate application while the base minimises the chances of any spillage. AN 305-74 is now also available in 300ml SEMCO cartridges. Surface Preparation In most applications, Weiconlock AN 305-74 Flange Sealing Adhesive does not require pre-treatment of the surface as even slightly oily surfaces cab still be adhered. That being said, best results will be achieved on cleaned and degreased surfaces (Weicon Surface Cleaner is ideal for this task). If required the parts should be slightly roughened. Processing Weiconlock AN 305-74 is ready to use from the moment you open the bottle. It should be evenly applied direct from the bottle/tube with the dispensing tip (avoid direct contact between the dispensing tip and metal). Weiconlock AN 305-74 should be applied evenly around the thread or flange surface. Do not pour any excess Weiconlock fluid that has made contact with metal back into the bottle. Even the smallest metal particles will cause the contents of the bottle to cure once the lid is re-closed. In series construction or production line situations, the use of manual or automatic applicators is suggested. For full use instructions, please consult the TDS & SDS for this product (both of which can be provided by your local AG branch). Adhesive Finder Tool Unsure if this adhesive is suitable for your application? Try Weicon’s handy Adhesive Finder tool!
